AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Setup tftp server9/6/2023 Connect the target board to the same network as the host using an Ethernet cable, power cycle it and it should boot over NFS.Note: Make sure not to start different TFTP implementations at the same time. => setenv nfsroot /home//var-fslc-yocto/rootfs (replace with the actual username) => setenv serverip (replace with the actual IP address of your host - run 'ifconfig' on the host to get it) Run the following in the U-Boot command line: Make sure you have a serial connection to the target.īoot the board and hit any key to stop the autoboot and get to the U-Boot command line. $ sudo ln -fs /proc/net/pnp /home//var-fslc-yocto/rootfs/etc/nf When using NetworkManager on the target, configure NetworkManager not to manage the interface used for the NFS boot by adding the following to /home//var-fslc-yocto/rootfs/etc/NetworkManager/nf: $ sudo rename 's/zImage-//' /tftpboot/zImage-*.dtb $ for f in tmp/deploy/images/im圆ul-var-dart/*.dtb do if ] & ] then sudo cp $f /tftpboot fi done $ sudo cp tmp/deploy/images/im圆ul-var-dart/zImage /tftpboot $ sudo /etc/init.d/nfs-kernel-server restart ![]() home//var-fslc-yocto/rootfs *(rw,sync,no_root_squash,no_all_squash,no_subtree_check) and add the following line to it (replace with the actual username): build_x11/tmp/deploy/images/im圆ul-var-dart/fsl-image-gui-im圆 ![]()
0 Comments
Read More
Leave a Reply. |